Engine area, note shock tower big block supports
Grind all bad welds and redo.
Seam Seal
Add new panels
Remove shock towers and add new cross member
From Rods and Customs
Side shot of cross member
Cross member from Rods and Customs
Mask off and prep for under coating
Under coating time
Make block off plates
Epoxy Coat Body
Cut vents out on hood and prep
Make side scoops to fit
Make tail lights fit
Alter tail panel to fit
Add Hood hinges
Pre fit hood pins
repair all body gaps
Make underside of trunk lid smooth
Make underside of hood smooth
Door rocker gap needs to be fixed
Great fit but still needs work
Test fit upper / lower scoops
Repair All body gaps
Trunk lid
Trunk, tail light area made to fit
Repair door gaps
Terrible fit, this means lots of work!
Bad gap where hood meet the cowl
Trunk lid gap getting better!
Bad gap front nose and hood.
Pre fit front, nothing lines up needs major work
Huge gap in tail panel!
Ready for the paint shop
Hood with stripes
trunk lid
Side scoops painted
www.asUwish.info